LTC2492
5
2492fd
SYMBOL
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
fEOSC
External Oscillator Frequency Range
(Note 16)
10
4000
kHz
tHEO
External Oscillator High Period
0.125
100
μs
tLEO
External Oscillator Low Period
0.125
100
μs
tCONV_1
Conversion Time for 1x Speed Mode
50Hz Mode
60Hz Mode
Simultaneous 50/60Hz Mode
External Oscillator
157.2
131
144.1
160.3
133.6
146.9
41036/fEOSC (in kHz)
163.5
136.3
149.9
ms
tCONV_2
Conversion Time for 2x Speed Mode
50Hz Mode
60Hz Mode
Simultaneous 50/60Hz Mode
External Oscillator
78.7
65.6
72.2
80.3
66.9
73.6
20556/fEOSC (in kHz)
81.9
68.2
75.1
ms
fISCK
Internal SCK Frequency
Internal Oscillator (Notes 10, 17)
External Oscillator (Notes 10, 11, 15)
38.4
fEOSC/8
kHz
DISCK
Internal SCK Duty Cycle
(Notes 10, 17)
45
55
%
fESCK
External SCK Frequency Range
(Notes 10, 11, 15)
4000
kHz
tLESCK
External SCK Low Period
(Notes 10, 11, 15)
125
ns
tHESCK
External SCK High Period
(Notes 10, 11, 15)
125
ns
tDOUT_ISCK
Internal SCK 32-Bit Data Output Time
Internal Oscillator (Notes 10, 17)
External Oscillator (Notes 10, 11, 15)
0.81
0.83
256/fEOSC (in kHz)
0.85
ms
tDOUT_ESCK
External SCK 32-Bit Data Output Time
(Notes 10, 11, 15)
32/fESCK (in kHz)
ms
t1
CS↓ to SDO Low
0
200
ns
t2
CS↑ to SDO Hi-Z
0
200
ns
t3
CS↓ to SCK↓
Internal SCK Mode
0
200
ns
t4
CS↓ to SCK↑
External SCK Mode
50
ns
tKQMAX
SCK
↓ to SDO Valid
200
ns
tKQMIN
SDO Hold After SCK
(Note 5)
15
ns
t5
SCK Set Up Before CS
50
ns
t7
SDI Set Up Before SCK
(Note 5)
100
ns
t8
SDI Hold After SCK
(Note 5)
100
ns
DIGITAL INPUTS AND DIGITAL OUTPUTS The denotes the specications which apply over the
full operating temperature range, otherwise specications are at TA = 25°C. (Note 3)
Note 1: Stresses beyond those listed under Absolute Maximum Ratings may
cause permanent damage to the device. Exposure to any Absolute Maximum
Rating condition for extended periods may affect device reliability and lifetime.
Note 2: All voltage values are with respect to GND.
Note 3: Unless otherwise specied:
VCC = 2.7V to 5.5V
VREFCM = VREF/2, FS = 0.5VREF
VIN = IN+ – IN, VIN(CM) = (IN+ – IN)/2,
where IN+ and INare the selected input channels.
Note 4: Use internal conversion clock or external conversion clock source
with fEOSC = 307.2kHz unless other wise specied.
Note 5: Guaranteed by design, not subject to test.
Note 6: Integral nonlinearity is dened as the deviation of a code from a
straight line passing through the actual endpoints of the transfer curve.
The deviation is measured from the center of the quantization band.
Note 7: 50Hz mode (internal oscillator) or fEOSC = 256kHz ±2% (external
oscillator).
Note 8: 60Hz mode (internal oscillator) or fEOSC = 307.2kHz ±2% (external
oscillator).
Note 9: Simultaneous 50Hz/60Hz mode (internal oscillator) or
fEOSC = 280kHz ±2% (external oscillator).
Note 10: The SCK can be congured in external SCK mode or internal SCK
mode. In external SCK mode, the SCK pin is used as a digital input and the
driving clock is fESCK. In the internal SCK mode, the SCK pin is used as a
digital output and the output clock signal during the data output is fISCK.
Note 11: The external oscillator is connected to the fO pin. The external
oscillator frequency, fEOSC, is expressed in kHz.
Note 12: The converter uses its internal oscillator.
Note 13: The output noise includes the contribution of the internal
calibration operations.
Note 14: Guaranteed by design and test correlation.
Note 15: The converter is in external SCK mode of operation such that the
SCK pin is used as a digital input. The frequency of the clock signal driving
SCK during the data output is fESCK and is expressed in Hz.
Note 16: Refer to Applications Information section for performance vs
data rate graphs.
Note 17: The converter in internal SCK mode of operation such that the
SCK pin is used as a digital output.
Note 18: For VCC < 3V, VIH is 2.5V for pin fO.
相关PDF资料
LTC2493IDE#TRPBF IC ADC 24BIT DELTA SIG 14-DFN
LTC2494IUHF#TRPBF IC ADC 16BIT W/PGA 38-QFN
LTC2495CUHF#PBF IC ADC 16BIT W/PGA 38-QFN
LTC2496IUHF#TRPBF IC ADC 16BIT DELTA SIG 38-QFN
LTC2498IUHF#TRPBF IC ADC 24BIT 16CH 38-QFN
LTC2600IUFD#PBF IC DAC OCTAL R-R 16BIT 20-QFN
LTC2602IMS8#TRPBF IC DAC 16BIT DUAL R-R VOUT 8MSOP
LTC2604IGN-1#TRPBF IC DAC 16BIT QUAD R-R OUT 16SSOP
相关代理商/技术参数
LTC2493CDE#PBF 功能描述:IC ADC 24BIT DELTA SIG 14-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率(每秒):15 数据接口:MICROWIRE?,串行,SPI? 转换器数目:1 功率耗散(最大):480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN(5x7) 包装:带卷 (TR) 输入数目和类型:16 个单端,双极;8 个差分,双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2493CDE#TRPBF 功能描述:IC ADC 24BIT DELTA SIG 14-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率(每秒):15 数据接口:MICROWIRE?,串行,SPI? 转换器数目:1 功率耗散(最大):480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN(5x7) 包装:带卷 (TR) 输入数目和类型:16 个单端,双极;8 个差分,双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2493CDEPBF 制造商:Linear Technology 功能描述:24bit Delta Sigma ADC Temp Sens LTC2493
LTC2493IDE#PBF 功能描述:IC ADC 24BIT DELTA SIG 14-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率(每秒):1M 数据接口:串行,SPI? 转换器数目:1 功率耗散(最大):- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘(4x4) 包装:Digi-Reel® 输入数目和类型:8 个单端,单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6
LTC2493IDE#TRPBF 功能描述:IC ADC 24BIT DELTA SIG 14-DFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率(每秒):45k 数据接口:串行 转换器数目:2 功率耗散(最大):315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC(0.295",7.50mm 宽) 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端,单极
LTC2494CUHF#PBF 功能描述:IC ADC 16BIT W/PGA 38-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率(每秒):15 数据接口:MICROWIRE?,串行,SPI? 转换器数目:1 功率耗散(最大):480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN(5x7) 包装:带卷 (TR) 输入数目和类型:16 个单端,双极;8 个差分,双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2494CUHF#TRPBF 功能描述:IC ADC 16BIT W/PGA 38-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率(每秒):15 数据接口:MICROWIRE?,串行,SPI? 转换器数目:1 功率耗散(最大):480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN(5x7) 包装:带卷 (TR) 输入数目和类型:16 个单端,双极;8 个差分,双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
LTC2494IUHF#PBF 功能描述:IC ADC 16BIT W/PGA 38-QFN RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率(每秒):1M 数据接口:串行,SPI? 转换器数目:1 功率耗散(最大):- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘(4x4) 包装:Digi-Reel® 输入数目和类型:8 个单端,单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6